Cisco WAP125-E-K9 Indoor Access Point
)
)
What is the price of Cisco WAP125-E-K9 in Bangladesh
The lowest price of Cisco WAP125-E-K9 in Bangladesh is Tk 12,500 only. Buy WAP125-E-K9 at low price in Bdstall. There is currently 0 seller.
Cisco WAP125-E-K9 Full Specification
| Item | Wireless Access Point |
|---|---|
| Model | ✅ WAP125-E-K9 |
| Brand | Cisco |
| Connectivity | Indoor |
| Wired Port | 10/100/1000 Ethernet |
| Wi-Fi | Up to 300Mbps |
| Speed | Up to 300Mbps |
| Protocol | Spanning Tree |
| Range | Single-band 2.4GHz |
| Security | WPA/WPA2, including enterprise authentication |
| System Requirements | Switch/router with PoE support, PoE injector, or AC power adapter |
- System memory
- 256 MB RAM
- 128 MB flash
- Cabling type: Category 5e or better
- Antennas: Internal antennas optimized for installation on desktop
- Led indicators: 1 multifunction LED
- Operating system: Linux
- Ports: 10/100/1000 Ethernet, with support for 802.3af /at PoE, power port for AC adapter included
- Power supply: External 12V/1A DC power jack and 802.3af/at PoE
- Buttons: Reset button, power on/off push button
- Lock slot: Slot for Kensington lock
- Network Capabilities
- VLAN support
- Number of VLANs: 1 management VLAN plus 8 VLANs for SSIDs
- 802.1X supplicant
- SSID-to-VLAN mapping
- Auto-channel selection
- Spanning tree
- Load balancing
- IPv6
- IPv6 host support
- IPv6 RADIUS, Syslog, Network Time Protocol
- Layer 2
- 802.1Q-based VLANs, 8 active VLANs plus 1 management VLAN
- Security:
- WPA/WPA2: Yes, including enterprise authentication
- Access control: Yes, management Access Control List plus MAC ACL
- Secure management
- HTTPS
- SSID broadcast
- Rogue access point detection
- Mounting and Physical Security
- Mounting options: Desktop
- Physical security lock: Kensington lock slot
- Quality of Service: QoS
- Wi-Fi Multimedia and Traffic Specification, client QoS
- Performance
- Wireless throughput: Up to 867-Mbps data rate (real-world throughput will vary)
- Recommended user support: Up to 64 connective users, 10 active users
Configuration
- Web user interface
- Built-in web user interface for easy browser-based configuration of HTTP, HTTPS
Management - Management Protocols
- Web browser, Simple Network Management Protocol v3, Bonjour
- Built-in web user interface for easy browser-based configuration of HTTP, HTTPS
- Remote management
- Event logging: Local, remote Syslog, email alerts
- Network diagnostics: Logging and packet capture
- Web firmware upgrade
- Firmware upgradable through a web browser, imported or exported configuration file
- Dynamic Host Configuration Protocol
- DHCP client
- IPv6 host
- HTTP redirect
- Wireless
- Frequency: Dual bands 2.4 and 5 GHz
- Radio technologies
- 802.11b: Direct-Sequence Spread-Spectrum
- 802.11a/g/n/ac: Orthogonal Frequency Division Multiplexing
- Modulation types
- 802.11b: BPSK, QPSK, CCK
- 802.11a/g/n/ac: BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM
- WLAN
- 802.11ac/n
- 2x2 Multiple-Input Multiple-Output with 2 spatial streams at 5 GHz
- 2x2 MIMO with 2 spatial streams at 2.4 GHz
- 20-, 40-, and 80-Mhz channels for 802.11ac
- 20 and 40 MHz for 802.11n
- PHY data rate up to 867Mbps
- Data rates supported
- 802.11a/b/g
- 802.11n: 6.5 to 300 Mbps
- 802.11ac: 6.5 to 867 Mbps
- 802.11a/b/g
- Wireless isolation: Wireless isolation between clients
- Wireless Distribution System (WDS)
- Fast roaming
- Multiple SSIDs: 8
- Wireless VLAN map
- WLAN security
- Wi-Fi Multimedia: Yes, with unscheduled automatic power save
- Operating Modes
- Access point: Access Point mode, WDS Bridging, Workgroup Bridge mode
- Environmental
- Power options: IEEE 802.3af Ethernet switch
- Cisco Power Injector: SB-PWR-INJ2-xx
- AC adapter included 12V/1A
- POE peak power: 6.5W
- Operating temperature: 0 to 40 Degrees
- Storage temperature: -20 to 70 Degrees
- Operating humidity: 10 to 85 percent noncondensing
- Storage humidity: 5 to 90 percent noncondensing
- Physical Specifications: 123 x 123 x 31mm
- Weight: 303gm
- Packet Contain
- WAP125 Wireless-AC/N Dual Band Desktop Access Point
- Power adapter 12V/1A
- Quick-start guide
- Ethernet network cable
Cisco WAP125-E-K9 Description
The Cisco WAP125-A-K9 Wireless-AC dual band desktop access point with PoE provides a simple, cost-effective way to expand secure, high-performance mobile networking. The Cisco WAP125-E-K9 indoor access point provides cost-effective 802.11 ac/n connectivity with speeds up to 867 Mbps for 2.4GHz and 5 GHz clients. This access point has a gigabit Ethernet LAN interface and enables flexible installation with power over Ethernet. It works out of the box with easy installation and a simple web-based configuration wizard. The Cisco WAP125-A-K9 indoor access supports both personal use and companies to secure Wi-Fi access, encoding all wireless transmissions with strong encryption. This indoor access point has also a remote management facility which is helpful for logging and packet capture.
Recently Viewed Item
Popular Wireless Access Point Brand
